PULLING TOOLS

S Pulling Tool Adapter

Designed to be sheared with the use of the skirt making contact with the body of the accessory.

The components are that of a “S” series Otis style pulling tool, using a short core creating a deep reach and top sub conversion that allows for the tool to be sheared by jarring down on the skirt,rather than the core.

The conventional top sub is removed from the pulling tool and replaced with a top sub which has a shearing system conversion contained within itself.

 

Applications:

 

The S pulling tool adapter is used mainly for running type “X” selective test tools, the “SSJ” is attached to tool string and ran to desired depth setting test tool in nipple profile.

This allows the option of remaining latched to fish neck at top of test tool equalizing stem or shearing and leaving test tool set in nipple profile.

By shearing with the bottom skirt of the pulling tool landing on the main body of the test tool eliminates damaging equalizing stem seats.

Where as conventional jar down to shear pulling tools require pin to be sheared by core contact with downward jarring.

Size2.00"2.50"3.00"
Upper Thread Conn.0.938-10UN0.938-10 UN1.062-10 UN
Fishneck OD (")1.375"1.375"1.75"
Fishneck OD (mm)34.93mm34.93mm44.45mm
Over all Length (")6.00"6.00"6.00"
Over all Length mm152mm152mm152mm
Maximum OD (")1.75"2.125"2.75"
Maximum OD (mm)44.45mm53.98mm69.85mm
Lower Thread Conn.1.375-12UN1.75-12UN2.125-12UN

PLEASE STATE PART DESCRIPTION AND SIZE WHEN ORDERING