FISHING TOOLS

Wire Grab – 2 Leg

Fishing slickline lost down well bore

The wireline grab consists of a hollow housing below the top sub.

Either two or three long slots are machined to the bottom of the housing to form the  prongs.

There are barbs attached to the inside of the prongs pointing upward.

The number of prongs will vary with the size of the tubing to maintain the strength of the grab.

Comes with interchangeable locator rings to suit different tubing drifts and / or ID’s.

 

Applications:

 

Primary use is fishing lost wireline, slickline, or electric line.

Retrieval of lost chunks of rubber or other maliable materials.

Retrieval of lost packer / WR equipment seals.

Size1.25"1.50"1.75"2.25"2.75"
Upper Thread0.625 UNC0.938-10 UN0.938-10 UN0.938-10 UN1.062-10 UN
Fishneck (")1.00"1.00"1.187"1.375"1.75"
Fishneck (mm)25.4mm25.4mm30.15mm34.93mm44.45mm
Over all Length (")23.50"23.50"23.50"23.50"23.50"
Over all Length (mm)597mm597mm597mm597mm597mm
Maximum OD (")1.31"1.656"1.906"2.347"2.867"
Maximum OD (mm)33.27mm42.06mm48.41mm48.4172.82mm

*Smaller or larger sizes available upon request

PLEASE STATE PART DESCRIPTION AND SIZE WHEN ORDERING