TOOLSTRING EQUIPMENT
Tubing Punch – Cam Style
The Cam Style (type “P”) tubing punch is used to cut or punch a hole in the tubing string to allow for communication between the tubing and annulus in a wellbore.
Typically used to drain the tubing so as to allow for a clean, more efficient way to trip pipe for the wellbore.
Applications:
The cam tubing punch can be used to allow for the tubing to drain if there is a blockage in the tubing string that will not allow fluid to drain normally.
The cam tubing punch can be used to allow for gas injection from the casing to the tubing to lift fluid.
Size | 1.900" | 2.062" | 2.375" | 2.875" | 3.5 |
Fishneck (") | 1.187" | 1.187" | 1.375" | 1.375" | 1.75" |
Fishneck (mm) | 30.14mm | 30.14mm | 34.93mm | 34.93mm | 44.45mm |
Maximum Body OD (") | 1.516" | 1.657" | 1.775" | 2.16" | 2.74" |
Maximum Body OD (mm) | 38.05mm | 42.09mm | 45.08mm | 54.86mm | 69.60mm |
Upper Thread Conn. | 0.938-10 UN | 0.938-10 UN | 0.938-10 UN | 0.938-10 UN | 1.062-10 UN |
Lower Thread Conn. | 0.938-10 UN | 0.938-10 UN | 0.938-10 UN | 0.938-10 UN | 1.062-10 UN |
Size | 4.50" |
Fishneck (") | 1.75" |
Fishneck (mm) | 44.45mm |
Maximum OD (") | 1.875" |
Maximum OD (mm) | 47.62mm |
Lower Thread Conn. | 1.062-10 UN |
Lower Thread Conn. | 1.062-10 UN |
*Alternate thread configurations, sizes, and lengths available upon request
PLEASE STATE PART DESCRIPTION AND SIZE WHEN ORDERING